Rubber Dust Boot Kit fit Navara D40 NP300 Prado 120/150 FJ Cruiser RB009K

Rubber Dust Boot Kit RB009K

Roadsafe 4WD offer a great range of replacement rubber dust boots for tie rod ends & ball joints. Made from high quality Chloropene Rubber (CR). CR material is treated for high ozone & weather resistance, low flammability, high oil,fuel & chemical tolerance. This will offer greater resistance to contaminants & increased longevity.

Dust boots are an integral part of the ball joint or tie rod end - as soon as a boot is torn or damaged the likelihood of contaminants entering into the operating mechanism of the joint is extremely high. As soon as dirt & grit enter the component, excessive wear will follow.

Avoid a costly repair bill, keep an eye on your dust boots, & if damaged replace immediately.

To suit the following Ball Joint

• BJ4083V2 - Navara D40 9/05-12/06 Extended 25MM (42.1MM OD)
• BJ4084 - Toyota Prado 120/150 & FJ CRUISER Extended 25MM
• BJ4981HD - Nissan Navara D40 NP300

Top hole 16.00mm / Bottom Hole 40.00mm / Height 31.00mm (Ring Retainer)

Boot Kit is a PAIR of Rubber Boots

The 4WD Shed is an Authorised Stockist for Roadsafe 4WD.