Rubber Dust Boot Kit fit Holden Colorado RG Isuzu DMAX RB317K

Rubber Dust Boot Kit RB317K

Please Note: We have been unable to confirm fitment on the new 2021 DMAX yet.

Roadsafe 4WD offer a great range of replacement rubber dust boots for tie rod ends & ball joints. Made from high quality Chloropene Rubber (CR). CR material is treated for high ozone & weather resistance, low flammability, high oil,fuel & chemical tolerance. This will offer greater resistance to contaminants & increased longevity.

Dust boots are an integral part of the ball joint or tie rod end - as soon as a boot is torn or damaged the likelihood of contaminants entering into the operating mechanism of the joint is extremely high. As soon as dirt & grit enter the component, excessive wear will follow.

Avoid a costly repair bill, keep an eye on your dust boots, & if damaged replace immediately.

To suit the following Ball Joint

• BJ4086 - 20mm Extended Version of  BJ3957HD MAZDA BT50 (GEN2)/FORD RANGER PX - Greasable Design w Circlip
• BJ4727HD - Holden Colorado RG DMAX 2012-2016
• BJ4670HD - Holden Colorado RG DMAX 2017-On

Top hole 19.20mm / Bottom Hole 43.00mm / Height 35.80mm (Ring Retainer)

Boot Kit is a PAIR of Rubber Boots

The 4WD Shed is an Authorised Stockist for Roadsafe 4WD.